Skip to content
  • There are no suggestions because the search field is empty.

Vehicle Wraps Lifting Weeks After Installation?

Vehicle wrap lifting 

One of the most frustrating failures occurs when a wrap looks perfect on installation day but begins lifting several weeks later.

These delayed failures are often linked to three closely related causes: improper outgassing, overstretching, and insufficient post-heating.

When solvent or eco-solvent prints are laminated before fully outgassing, trapped solvents can remain within the graphic. Over time, these solvents can contribute to shrinkage, tunneling, bubbling, and adhesion loss.

Installation practices can also play a significant role. Stretching a film beyond its intended limits creates stress within the material. While the graphic may initially appear smooth and conformable, the film naturally attempts to recover over time.

This recovery can lead to:

    • Lifting in channels
    • Edge shrinkage
    • Distortion
    • Bubble formation
    • Premature failure

Post-heating is designed to address these stresses. Proper post-heating helps remove film memory and improves adhesive wet-out in stretched areas. Deep channels, recesses, corners, and edges are particularly important areas to target.

When installers skip post-heating or fail to reach the proper temperature, the wrap is far more likely to lift in high-stress areas.

Most delayed wrap failures can be traced back to one of these three factors. Understanding and controlling them can significantly increase the service life and reliability of vehicle graphics.